DIY Tabletop Fire Bowl – Bitcoin Value
Fire Pits

DIY Tabletop Fire Bowl


DIY Tabletop Fire Bowl

.

.

If you’re looking to add a little flare to your outdoor space, this DIY concrete fire bowl will do the trick!

Begin with a bag of quick setting concrete, water, two bowls – one bowl smaller than the other, non stick kitchen spray, mesh wire, chafing fuel and fire safe rocks.

Spray the inside of the large bowl and outside of the small bowl. Mix the concrete until it is the consistency of peanut butter. Fill the large bowl 3/4 of the way full.

Press the smaller bowl into the concrete, squeezing the concrete up to the rim of the larger bowl. Make sure the smaller bowl is centered. Add rocks to weigh down the small bowl or it may float out of the concrete.

When the concrete is nearly dry, remove the bowls. Smooth out the concrete with a wet sponge.

Allow the concrete to completely cure according to the instructions on your concrete packaging.

Add a chafing fuel can and wire mesh to the bowl. (You’ll need to prepare by opening your chafing fuel can if you’re ready to light your fire)

Surround the can with fire-safe rocks (check with your Home Depot associate to see what they have available.) Don’t place the rocks directly over the fuel can. Light and enjoy!

For complete detailed instructions please see the link below.

If you’re looking to add a little flare to your outdoor space, this DIY concrete fire bowl will do the trick! Begin with a bag of quick setting concrete, water, two bowls – one bowl smaller than the other, non stick kitchen spray, mesh wire, chafing fuel and fire safe rocks. Spray the inside of the large bowl and outside of the small bowl. Mix the concrete until it is the consistency of peanut butter. Fill the large bowl 3/4 of the way full. Pres

.

.

Tags

Related Articles

Back to top button
Close
Close

Adblock Detected

Please Close Adblock. Stay home ! Stay Safe !