DIY Plant Stand – Bitcoin Value
Woodworking Crafts Ideas

DIY Plant Stand


DIY Plant Stand

.

.

Hey there! Join us on Instagram and Pinterest to keep up with our most recent projects and sneak peeks!

45.6K shares Facebook

Twitter

Pinterest

I am so excited to share my latest project with you! This one couldn’t be more simple… and fun! Check out my DIY Plant Stand!

How cute are those??

You guys are going to love how simple these babies are… And cheap! The stands can be modified to any pot, and the cost of wood for one stand is under $10… Can I get a woohoo??

So… Let’s get started!

Supply List for 1 Plant Stand

Kreg Jig

2.5″ pocket hole screws

2 – 2 x 3 x 8 cedar posts (I used these from Home Depot)

Your first step will be to make your cuts. I used my Ridgid 12″ Miter Saw for this part, but you can also have the guys at Home Depot cut yours if you need them too. Another great saw would be the new 18V Ryobi Miter Saw! Have y’all seen this thing? It’s the perfect size for those of you without a large workspace, and it uses the same batteries as the Ryobi drill!

Cut List

4 cuts at 30″

2cuts at 5.5″

1 cut at 12″

Once your cuts are made, you are ready to add the pocket holes! I used my Kreg Jig to make mine. For those of you that have no clue what a Kreg Jig is, you can check out our video HERE to help break it down. It’s a simple tool used to help you join your wood. You can see our very favorite model of the Kreg Jig HERE on Amazon!

This is how I lined up my 2×3 in my Kreg Jig for these pocket holes. For this project, I made 1.5″ pocket holes and I will be attaching using 2.5″ pocket hole screws.

I used my Ryobi 18V drill to make all of my holes using the Kreg bit that comes with the Kreg Jig. You can see below where I put all of my pocket holes. The 12″ piece will have two on each end. The smaller 5.5″ pieces will have 4 on each piece. Two will face one direction, and two will face the other. Just make sure you don’t overlap them. They should fit side by side like mine do!

Now you are ready to attach. I made my X’s first using my smaller cuts. Each planter will have an X that looks like this. I just centered the 5.5″ pieces on the 12″ piece and attached them using 2.5″ pocket hole screws.

I then decided where I wanted my planters to stand and marked a line on each 30″ piece. I went with 6″ for mine. Yours will depend on the pots you use. I found my copper colored pots at Home Depot. I then attached each side making sure to line up my pieces on the lines so it would all be even. I also used some Gorilla Wood Glue at each joint.

That’s it! I told you it was simple!

My last step was dropping the pots inside and putting them on my porch! I decided to keep mine raw. I like the look of raw cedar… You can also stain or paint yours! Here’s a few more shots of mine!

I filled mine with mums, hoping to channel some Fall weather here! Wish me luck on that ;-)!

Thanks so much for stopping by guys! I would LOVE for you to share and PIN these with all your peeps. Let me know if you have any questions at all!

~Whitney

45.6K shares Facebook

Twitter

Pinterest

Free Woodworking Plans to build a simple DIY Plant Stand by Shanty-2-Chic.com!

.

.

Tags

Related Articles

Back to top button
Close
Close

Adblock Detected

Please Close Adblock. Stay home ! Stay Safe !